H50751H Inset hopper waste disposal unit

0.75hp Inset hopper waste disposal unit manufactured from 0.9/1.2mm thick stainless steel for welding into dishwash tabling and can be mounted to give either front, left or right hand side feed, depending on the size of tabling. The hopper and motor are supplied separately for assembly on site. The hopper is fitted with a magnetic cutlery saver. The motor is activated using the controls on the front panel, however a separate control box can be supplied as an extra - see below.
Suitable for plate waste, left overs, vegetables and peelings, very fine fish and chicken bones.

Dimensions: 520 x 520 x 690 mm

Technical specification:
Meals capacity: 400 per day
Nominal capacity: 200kg/hr
Motor voltages: .75hp 1phase, 0.55 kw, 240v 50hz
Motor control: Wall mounted, manual reset
Fuse rating: 240v 1phase 50hz 25amps
Full load current 5.6amps
Water connection: Cold supply to 15mm pipe connector
Recommended flow rate 12 litres per min.
inlet pressure minimum of 0.3 bar
Waste connection: 38mm BSP outlet bend to waste
Motor: NEMA ULCSA

Extras
F4001 Remote control box